You are here: Home » Toxic Gases – non Hazardous Area – Analog, Digital » TGT-1000

TGT-1000

Toxic Gas Transmitter TGT 1000
TGT 1000 is a series of direct use Sensor + Transmitter combination units housed in weather-proof (IP65) enclosures.  Transmitters are designed for standard two-wire operation where the output is supplied via the same wire pair as the power supply. The external circuit loop is connected to the transmitter via a screw terminal Connector.The  Units  are  supplied  pre-calibrated  for  the  specified range, and the sensitivity of the device should not drift by more than 2% of full signal per month. Some sensors have cross interference effect of  other gases. It is important to specify air composition to help choose appropriate sensor.Except  requiring  periodic  re-calibration,  transmitters  are maintenance-free,    and    should   give faultless service throughout the working life of the sensor.TGT is available with  many    optional enhancements like 4 digit  LED  display,  multi-parameter back  lit LCD  display. HART  protocol  output.  Modbus  protocol,  PC  calibration and programming facility etc.
Request a quote
 Features:
  • Very Low Maintenance
  • High Sensitivity Sensor
  • 4 digit LED display
  • Microcontroller SMD Components
  • Weather proof ABS Dust Tight IP 65 enclosure
  • Aeasthetical Looks
  • 2 Wire 4-20 mA output
  • Loop Powered
  • Wide optg Voltage. 10-27VDC
  • Compatible – DCS, PLC, PRISM Monitors
  

 

Gas Ranges Available
Carbon Monoxide CO 2000, 5000, 10,000 ppm
Hydrogen Sulphide H2S 50, 200, 1000, 2000 ppm
Sulphur Dioxide SO2 20, 100, 2000 ppm
Nitorogen Dioxide NO2 20 ppm
Chlorine Cl2 10, 20 ppm
Nitric Oxide NO 250, 5000 ppm
Phosphene PH3 10 ppm
Ethylene Oxide E2O 100 ppm
Hydrogen Cyanide HCN 100 ppm
Oxygen O2 25% Vol

 

Technical specifications

Sensor Electrochemical, Galvanic
Type Diffusion, Suction ( optional)
Signal output 4-20 mA proportional output
Sensor out of range > 21.5 mA
Power supply  10 -30 V DC
Digital Output HART  RS485 Modbus
Protection Reverse Connection
Warm-Up time Max. 2 minutes
Stabilization time Less than 2 minutes
Operating Temperature -20 ºC to +50 ºC
Relative Humidity 0-95 % RH, Non condensing
Pressure 90-110 KPa
Calibration Either Digitally, Via HART RS485 Interface or with Zero/SPAN controls
Max Loop Res. 700 R at 24V
Weight Less than 250 gms
Mounting Wall/Floor  with Brackets/Stand
Enclosure Weatherproof IP65
Enclosure Material ABS
Sensor Housing PVC,SS (Optional)
Connections 2 Screw terminal (Wire dia 0.2-2.5 mmsq)

Safety(?) News